Cameo ZENIT W300 Bedienungsanleitung Seite 10

Settings
Wireless Setting =
Display Reverse =
Display Backlight =
DMX Fail =
Dimmer Curve =
Dimmer Response =
Color Calibration =
Autolock =
LED Frequency =
10
W-DMX settings
(Wireless-DMX)
Flip display
Display lighting
Operating status with DMX
signal fault
Dimmer curve
Dimmer sensitivity
Color calibration
(If one of the DMX factory
calibration modes is activated,
no other calibration can be
selected and the message
"no possible change in this
DMX Mode" will be shown
on the display. If one of the
DMX user calibration modes
is activated, RAW can be
selected as the alternative
calibration.)
Automatic locking of the
controls
LED PWM frequency
W-DMX On/Off On = W-DMX enabled
Off = W-DMX disabled
Operating Mode Receive = W-DMX module as receiver
Receive = W-DMX module as sender
Transmitting Mode G3 = G3 broadcasting standard
G4S = G4S broadcasting standard
Link Link = pair with W-DMX units. W-DMX must be enabled
on all devices, and the pairing with a transmitter be
retained (Receive Reset).
Unlink = decoupling of all devices
Receive Reset No = Do not retain transmitter pairing
Yes = Retain transmitter pairing
On = rotate display by 180° (e.g. for overhead installation)
Off No display rotation
On On permanently
Off Deactivation after approximately 1 minute of inactivity
Hold Last command is retained
Blackout Activates blackout
Full On All the LEDs are 100%
Stand Alone Spotlight switches to the last selected stand-alone mode
Linear Light intensity increases linearly with DMX value
Exponential Light intensity can be finely adjusted at lower DMX
values and broadly adjusted at higher DMX values
Logarithmic Light intensity can be broadly adjusted at lower DMX
values and finely adjusted at higher DMX values
S-Curve Light intensity can be finely adjusted at lower and
higher DMX values and broadly adjusted at medium
DMX values
LED Lamp responds abruptly to changes in DMX value
Halogen Lamp behaves like a halogen spotlight with soft bright-
ness changes
RAW individual color calibration. Brightness adjustment of 4
RGBW LED groups for all modes in the range 000-255
User calibration Individual color calibration. Cross-mode brightness
setting of the 4 LED groups RGBW with values from
000 - 255
Factory calibration Factory-default calibration of R, G, B, and W (across all
operating modes). Select this setting to ensure the con-
sistent-looking presentation of color macros in stand-
alone mode and to control color macros with DMX.
On Automatic locking of the controls after approximately 1
minute of inactivity. Display shown upon attempted use:
"Locked!"
To unlock: Press and hold UP and DOWN simultaneously
for approx. 5 seconds
Off Automatic locking of the controls is disabled
800Hz / 1200Hz / Configuration of LED PWM frequency
2000Hz / 3600Hz /
12kHz / 25kHz