Settings: Password; Password Protection - Pentair INTELLIFLO VSD series Bedienungsanleitung

17

Settings: Password

When the Password feature is enabled, the pump will enter into password protection mode for a
preprogrammed amount of time after the last button is pressed. The entered password is any combination
of four (4) digits.
To access the Password menu:
1. Check that the green power LED is on.
2. Press the Menu button. "Settings" is displayed.
3. Press the Select button. "Pump Address" is displayed.
4. Use the Up or Down arrow button to scroll to "Password".
5. Press the Select button. The default setting is "Disabled".
6. Press the Select button to change the setting.
7. Press Up or Down arrow button to change the setting to Enabled".
8. Press the Enter button to save the setting.
9. Press Down arrow button. "Password Timeout" is displayed.
Factory default time is 10 minutes, this means the pump will go into Password Protection
mode 10 minutes after the last control panel key press.
10. Press Select to change time setting from 1 minute to 6 hours.
11. Press the Enter button to save the setting.
12. Press Down arrow button. "Enter Password" is displayed.
13. Press Select to change the setting.
14. Press Left or Right arrow button to move cursor and press up and down arrow to change
password number to desired setting.
15. Press the Enter button to save the setting. To cancel any changes, press the Escape button to
exit edit mode without saving.
16. Press the Escape button to exit.

Password Protection

Password: The default for this setting is disabled, which means the pump does not have password
protection. When this feature is enabled, for a preset amount of time after the last button is pressed, the
pump display will prompt for the password before allowing access to the control panel and buttons. The
password must be a four (4) numeric digit password. Write down the password and keep in a secure place.
• When the pump is password protected the pump can always be turned off by pressing the
Start/Stop button.
• When running the pump in manual mode it cannot be turned back on with the press of the
Start/Stop button.
• Pressing the Start/Stop button when the pump is off will return it back to the Running
Cycles Mode and will run at the next scheduled run time. If the present time is within the
scheduled run time the pump will run the scheduled speed.
• All functions including programming are disabled in Password Protection Mode.
If any button other than the Start/Stop button is pressed, the screen reads Enter Password.
•
• When Password Protection is enabled there is a key icon displayed in the upper left side of
the LCD.