Specifications; Additional Safety Rules - Makita 6822 Betriebsanleitung

ENGLISH
1 Locking sleeve
2 Approximately 1 mm
3 Locator
4 Bit

SPECIFICATIONS

Model
Capacities
Self drilling screw .......................................... 6 mm
Drywall screw ................................................ 5 mm
No load speed (RPM) ................................ 0 – 4,000
Overall length ............................................... 258 mm
Net weight ....................................................... 1.3 kg
• Due to the continuing program of research and
development, the specifications herein are subject
to change without prior notice.
• Note: Specifications may differ from country to
country.
Power supply
The machine should be connected only to a power
supply of the same voltage as indicated on the
nameplate, and can only be operated on single-phase
AC supply. They are double-insulated in accordance
with European Standard and can, therefore, also be
used from sockets without earth wire.
Safety hints
For your own safety, please refer to enclosed safety
instructions.

ADDITIONAL SAFETY RULES

1. Always be sure you have a firm footing.
Be sure no one is below when using the
machine in high locations.
2. Hold the machine firmly.
3. Keep hands away from rotating parts.
4. When driving into walls, floors or wherever
''live'' electrical wires may be encountered, DO
NOT TOUCH ANY METAL PARTS OF THE
MACHINE!
Hold the machine only by the insulated grasp-
ing surfaces to prevent electric shock if you
drive into a ''live'' wire.
5. Do not touch the bit or the workpiece immedi-
ately after operation; they may be extremely
hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
4
Explanation of general view
5 Magnetic bit holder
6 Speed control screw
7 Switch trigger
8 Lock button
OPERATING INSTRUCTIONS
6822
Depth adjustment
The depth can be adjusted by turning the locking
sleeve. Turn it in ''A'' direction for less depth and in ''B''
direction for more depth. One full turn of the locking
sleeve equals 1.5 mm change in depth. (Fig. 1)
Adjust the locking sleeve so that the distance
between the tip of the locator and the screw head is
approximately 1 mm as shown in Fig. 2 or 3. Drive a
trial screw into your material or a piece of duplicate
material. If the depth is still not suitable for the screw,
continue adjusting until you obtain the proper depth
setting. (Fig. 2 & 3)
Removing or installing bit (Fig. 4 & 5)
Important:
Always be sure that the machine is switched off and
unplugged before removing or installing the bit.
To remove the bit, first pull the locator out of the
locking sleeve. Then grasp the bit with a pair of pliers
and pull the bit out of the magnetic bit holder. Some-
times, it helps to wiggle the bit with the pliers as you
pull.
To install the bit, push it firmly into the magnetic bit
holder. Then install the locator by pushing it firmly
back onto the locking sleeve.
Switch action (Fig. 6)
CAUTION:
Before plugging in the machine, always check to see
that the switch trigger actuates properly and returns to
the ''OFF'' position when released.
To start the machine, simply pull the trigger. Machine
speed is increased by increasing pressure on the
trigger. Release the trigger to stop. For continuous
operation, pull the trigger and then push in the lock
button. To stop the machine from the locked position,
pull the trigger fully, then release it. A speed control
screw is provided so that maximum machine speed
can be limited (variable). Turn the speed control
screw clockwise for higher speed, and counterclock-
wise for lower speed.
NOTE:
Even with the switch on and motor running, the bit will
not rotate until you fit the point of the bit in the screw
head and apply forward pressure to engage the
clutch.
9 Counterclockwise
0 Clockwise
q Reversing switch lever