Safety 1st PrimeoFix Gebrauchsanweisung Seite 26

consulting the manufacturer.
• Do not use the child restraint device without the
cover. Do not replace the seat cover with a cover
other than that recommended by the manufac-
turer, because it will have a direct effect on the
functioning of the child restraint.
• This child restraint is effective only if the
instructions for use are respected.
• Always fasten the child restraint even when the
child is not sitting in it.
• Never place heavy objects on the rear parcel
shelf, to avoid the danger of projectiles in the
event of an accident.
• Always check that no part of the seat or the
harness is trapped under a seat or in the vehicle
door.
• Folding seats must always be locked in place.
• After purchasing, install the seat in your vehicle.
If you encounter any installation problems due to
the length of the vehicle seat belt, contact your
distributor immediately.
• If in any doubt about the correct installation or
use of the system, the user is advised to contact
the distributor or the manufacturer of the child
restraining device system.
Care
Fabric:
• Before cleaning check the label sewn into the
fabric, you will fi nd the wash symbols indicating
the method of washing each item.
EN
0529005_Manual_PrimeoFix_S1st_2014.indd 26
Washing symbols :
Shell:
• Clean the shell using a damp cloth.
Environment
Keep all plastic packaging materials out of reach
of your child to avoid the risk of suffocation.
For environmental reasons, when you have
stopped using this product, we ask that you
dispose of the product in the proper waste
facilities in accordance with local legislation.
Questions
If you have any questions, contact your local Safety
1st retailer (see www.safety-1st.com for contact
information). Make sure that you have the
following information on hand:
- Serial number at the bottom of the orange ECE
sticker
- Make and type of car and seat on which the
Safety 1st PrimeoFix is used
- Age, height and weight of your child
26
17/10/13 17:25