How To Test Your Camera - Optika MS-2 Bedienungsanleitung

It may happen sometimes that Windows doesn't recognize a Camera using one of your PC USB ports, while
gives no problem using another port.
To prevent any installation problem we have put on the CD all the software and drivers in specific folders with
an appropriate names.

How to test your Camera

In order to check if your Camera works correctly, it's not necessary to put it into the microscope: it's enough to
connect it into the USB port, run Vision Lite using the icon on your desktop, select the right driver and check
whether the shown image is not totally black.
Select the right drivers
It's very easy:
OPTIKA TCD 3.0
With Optika Vision Lite you have to tell the Software which is the Driver by selecting the microscope-shaped
icon.
Getting started with Optika Vision Lite, a very easy measuring and documentation
software.
Run Optika Vision Lite by clicking on its icon on your desktop.
Select the right Driver for capturing the image. Note that after choosing the driver and before capturing the image
you can set the brightness, saturation, gamma ecc..
Then you can capture the image.
The image is now ready for being manipulated using Optika Vision Lite.
Page 19