Mantis DELUXE 4-STROKE TILLER – 7265 Bedienungsanleitung Seite 12

Assembly
uPPer hAnDle POSiTiOninG
7
• Lift the upper handles until they line up
with the lower handles and fully tighten
the knobs at the pivot point.
10
• Lastly, adjust your handle height by
loosening the upper 2-prong knobs and
removing the round knobs then sliding the
upper handles to the desired position.
12
(cOnTinueD)
8
• Cap the exposed bolts with the acorn
improper Throttle installation can cause
tines to rotate unexpectedly.
Deluxe 4-Stroke Tiller Operator's Manual
nuts and tighten with your 7/16
(11 mm) wrench until snug. Do not
over tighten.
11
• Then re-insert the round knobs and
re-tighten the 2-prong knobs
Make sure you have installed the handles proper-
ly. when you stand behind your tiller, holding the
handles, the fender warning label should face you.
Be sure you have proper throttle movements and
that the throttle cable is not wrapped or twisted
around the handle bar. hold down the lockout
lever, fully squeeze the throttle trigger and let go.
The throttle triangle must click in both directions.
If there is any doubt, remove air filter and visu-
ally check that the throttle triangle hits both the
idle screw and the full open stop. ThiS MuST Be
DONE bEFOrE StArtINg tHE ENgINE.
9
• Attach the throttle cable clips to
the upper and lower handles.
Make sure the cable is not
wrapped or twisted and you have
the proper throttle movement.
iMPOrTAnT nOTe:
iMPOrTAnT nOTe:
Before you use your MAnTiS Tiller, read the
Safety rules & Warnings on pages 4-6
iMPOrTAnT nOTe: