Preparation; Things To Be Done For Energy Saving - Grundig GDN 17835 FX Bedienungsanleitung

4 Preparation

4.1 Things to be done for
energy saving
Connecting the product
A
to electric energy saving
systems is risky as it may
cause damage on the
product.
•
Do not leave the doors of your
refrigerator open for a long
time.
•
Do not put hot food or drinks in
your refrigerator.
•
Do not overload the refrigerator,
cooling capacity will fall when
the air circulation inside is
hindered.
•
In order to store maximum
amount of food in the freezer
compartment, the icematic,
available in the freezer
compartment and easily
removable by hand, shall be
taken out. Net volume and
energy consumption values
declared on the power data
plate of your refrigerator
are measured and tested by
removing the icematic. Do
not remove the shelves inside
the freezer compartment
and on the door of freezer
compartment shall not be
removed and they shall always
be used they provide ease of
use and efficiency in energy
consumption.
•
Airflow should not be blocked
by placing foods on the sides of
the freezer compartment fan.
14
A minimum distance of 3 cm
shall be provided on the sides of
protective fan cover.
•
The baskets/drawers that
are provided with the chill
compartment must always be in
use for low energy consumption
and for better storage
conditions.
•
Food contact with the
temperature sensor in the
freezer compartment may
increase energy consumption of
the appliance. Thus any contact
with the sensor(s) must be
avoided.
•
Depending on the features of
your product, thawing frozen
food in fridge compartment will
both provide energy saving and
preserve the food quality.
•
Do not allow contact of the food
with the fridge compartment
temperature sensor shown in
the figure below.