Installation; Appropriate Installation Location; Installing The Plastic Wedges; Adjusting The Feet - Grundig GDN 17835 FX Bedienungsanleitung

3 Installation

3.1 Appropriate installation
location
Contact an Authorized Service for
the installation of the product. In
order to prepare the product for use,
refer the information in the user
manual and ensure that electrical
installation and water installation
are appropriate. If not, call a qualified
electrician and technician to have any
.necessary arrangements carried out
WARNING:
Manufacturer shall not be
B
held liable for damages
that may arise from
procedures carried out by
unauthorized persons.
WARNING:
must not be plugged
B
in during installation.
Otherwise, there is the
risk of death or serious
injury!
WARNING:
clearance of the room
where the product shall be
place is so tight to prevent
A
passing of the product,
remove the door of the
room and pass the product
through the door by
turning it to its side; if this
does not work, contact the
authorized service.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least 30 cm
away from heat sources such as
hobs, heater cores and stoves and
at least 5 cm away from electrical
ovens.
12
• Product must not be subjected to
• Appropriate air ventilation must
• Do not install the product in places
3.2 Installing the
Plastic wedges supplied with the
product are used to create the
distance for the air circulation
between the product and the rear
wall.
Product
1.
2.
If the door

3.3 Adjusting the feet

If the product stands unbalanced
after installation, adjust the feet
on the front by rotating them to the
right or left.
direct sun light and kept in humid
places.
be provided around your product
in order to achieve an efficient
operation. If the product is to be
placed in a recess in the wall, pay
attention to leave at least 5 cm
distance with the ceiling and side
walls.
where the temperature falls below
-5°C.
plastic wedges
To install the wedges, remove the
screws on the product and use the
screws supplied together with the
wedges.
Insert the 2 plastic wedges onto
the rear ventilation cover as
illustrated in the figure.