Hot Surface Warning; Preparation; What To Do For Energy Saving; First Use - Grundig GLPN 66820 X Bedienungsanleitung

4.6 Hot Surface Warning

The side walls of your product are equipped
with cooler pipes to enhance the cooling
system. High pressure fluid may flow

5 Preparation

Read the "Safety Instructions" sec-
tion first!

5.1 What to Do for Energy Saving

Connecting the product to elec-
tronic energy-saving systems is
harmful, as it may damage the
product.
• This refrigerating appliance is not inten-
ded to be used as a built in appliance.
• Do not keep the refrigerator doors open
for long periods.
• Do not place hot food or beverages into
the refrigerator.
• Do not overfill the refrigerator; blocking
the internal air flow will reduce cooling
capacity.
• Using the below drawer when storing is
strongly recommended.
• Make sure the foods are not in contact
with the cooler compartment temperat-
ure sensor described below.
• If they are in contact with the sensor, en-
ergy consumption of the appliance might
increase
through these surfaces, and cause hot sur-
faces on the side walls. This is normal and
it does not require servicing. Be careful
when you contact these areas.
• Food shall be stored using the drawers in
the cooler compartment in order to en-
sure energy saving and protect food in
better conditions.

5.2 First Use

Before using your refrigerator, make sure
the necessary preparations are made in line
with the instructions in "Safety and Environ-
mental Instructions" and "Installation" sec-
tions.
• Keep the product running without placing
any food inside for 6 hours and do not
open the door, unless absolutely neces-
sary.
• The temperature change caused by open-
ing and closing of the door while using
the product may normally lead to con-
densation on door/body shelves and
glassware placed in the product.
A sound will be heard when the
compressor is engaged. It is nor-
mal for the product to make noise
even if the compressor is not run-
ning, as fluid and gas may be com-
pressed in the cooling system.
It is normal for the front edges of
the refrigerator to be warm. These
areas are designed to warm up in
order to prevent condensation.
For some models, indicator panel
turns off automatically 1 minute
after the door closes. It will be re-
activated when the door is opened
or any button is pressed.
EN / 15
EN
FR
DE
ES