Installation; Appropriate Installation Location - Grundig GTNI 10320 Bedienungsanleitung

3. Installation

To make the product ready for
use, make sure that the electricity
installation is appropriate before
calling the Authorised Service
Agent. If not, call a qualified
electrician to have any necessary
arrangements carried out.
Preparation of the
C
location and electrical
installation at the place
of installation is under
customer's responsibility.
Product must not be
B
plugged in during
installation. Otherwise,
there is the risk of death
or serious injury!
WARNING:
shall not be held liable for
B
damages that may arise
from procedures carried
out by unauthorised
persons.
WARNING:
installation, visually
A
check if the product has
any defects on it. If so,
do not have it installed.
Damaged products cause
risks for your safety.
Make sure that the power
cable is not pinched or
C
crushed while pushing
the product into its place
after installation or
cleaning procedures.
3.1 Appropriate
A
•
•
Manufacturer
•
Prior to
•
•
•
installation location
WARNING:
of the room where the
product will be placed
is too small for the
product to pass, then the
product's doors must be
removed and the product
must be turned aside to
pass it through.
Choose a place at where
you would use the product
comfortably.
Install the product at least 30
cm away from heat sources
such as hobs, ovens, heater
cores and stoves and at least 5
cm away from electrical ovens.
Product must not be subjected
to direct sun light and kept in
humid places after installation.
Appropriate air ventilation
must be provided around your
product in order to achieve an
efficient operation.
the product is to be placed in a
recess in the wall, pay attention
to leave at least 5 cm distance
with the ceiling and side walls.
Do not place the product on
the materials such as rugs or
carpets.
Place the product on an even
floor surface to prevent jolts.
Your product can operate in
ambient temperatures between
-15°C to +43°C.
If the door
If
E
DA
SV
NO
FIN
IT
NL
13