en
5.2 MAINTENANCE MENU
During normal operation, you can access to the Maintenance menu that allows you to view and
modify some parameters in addition to the Rapid installation menu.
To access the maintenance menu press "+" for about 3 seconds.
The navigation method, parameter editing and saving is the same as described in section 5.1.
If you want to go back to the initial display it is necessary to scroll to the end of the parameter list until
this displayis shown:
Press ENTER to exit from the Maintenance menu and modified parameters are saved in the memory.
Factory settings
Access to the Maintenance menu by pressing "+" for about 3 seconds.
Press " " and the display will show the parameters for the Maintenance menu. Scroll through the
parameters until the display shows:
Press "+" to change to 1.
Press ENTER and hold it down until Done is displayed.
The display shows:
This procedure restores the factory settings and AQUONTROLLER will automatically switch off and
then back on again.
48
Save & Exit
With ENTER
Load Default
0
Default OK