Fault Finding; Technical Data - Kemper autoflow Bedienungsanleitung

7. Fault finding

7.1 KEMPER autoflow
If there is a sudden change in air supply while using the KEMPER autoflow
it is necessary to check the following:
• All parts of air-supplying system are assembled properly.
• The battery is fixed properly to the unit.
• The battery charger is working correctly (check LED's).
• Filters are not too saturated.
• No holes are in the air hose.
• The inner sealing of the hood is not damaged.
• The working time of the battery after full charge has not decreased
(if so, it is necessary to replace battery).
7.2 KEMPER freshflow
If there is a sudden change in air supply while using the KEMPER freshflow
it is necessary to check the following:
• All parts of the respiratory system are assembled properly.
• The filter in the air conditioner (if attached) is not too saturated.
• The air hose and the compressed air hose are not damaged.
• The inner sealing of the hood is not damaged.
• The compressed air pressure is sufficient.
8. Storage
All parts of the KEMPER respiratory system must be stored in an environment at a temperature between
0° C and 60° C and a humidity from 20 to 80 %. Filters can be used up to two years from the date of
production if stored in original unopened package. After two years they need to be exchanged.

9. Technical data

9.1 KEMPER autoflow
Min. airflow
Weight
Noise level
Battery lifetime
Charging time
Operating time
Belt size
Recommended working temperature
Recommended working humidity
Certification
® respiratory system
® respiratory system
® respiratory system
140 to 210 l/min
900 g
55 to 61 dB
500 to 700 charging cycles
10 to 14 hours
6 to 15 hours
80 to 100 cm
10 to 40° C
20 to 80 % RH
EN 12 941 TH2P/TH3P
® respiratory system,
® respiratory system,
21