Accessories - REVELL Control HOT SHOT HELICOPTER Bedienungsanleitung

HeLIcoPter:
Stabilizer
Central rotor
LED indicator
Landing skid
coNtroLLer (mode 2):
Starting position
caution: The throttle stick must be in
the down position when the controller
is turned on.
Antenna
Throttle trim dial
Controller for
throttle and yaw
(binding button)
Yaw trim dial
Mode 2 controller functions (throttle on left side)
1. To open the battery cover, slide
it to the side.
Note: Before charging, always wait 10 to 15 minutes for the battery to cool down in order to avoid damage.
Abb. 1 Abb. 2
charging via the controller
1. Ensure that the controller batteries are fully charged (fig. 1).
2. Remove the cover from the LiPo batteries in the controller (fig. 2).
3. Insert the LiPo battery in the battery compartment. Switch the controller on.
If the battery is connected correctly, the green LED on the charger lights up (fig. 3).
4. After approx. 45 minutes, the battery is completely charged and the green LED
light goes off.
the helicopter can fly for approx. 10 minutes with a fully charged battery.
The charging process is electronically monitored and stops automatically after 60 minutes. Never leave the helicopter unattended when recharging.
Helicopter and controller
Fuselage fixing pins
Battery compartment
on underside
Inserting the Batteries
2. Insert four 1.5 V AA batteries according to the
polarity in the battery compartment.
charging the Helicopter Battery
Abb. 3
Abb. 1
Tail rotor
DIGItAL coNtroLLer DISPLAY:
Throttle display
Battery life display for
the controller
Throttle trim display
Yaw trim display

AcceSSorIeS:

Digital controller display
Automatic LiPo charging
unit for two LiPo batteries
Pitch trim dial
Controller for pitch and roll
(switch between beginner
and advanced modes)
Roll trim dial
3. Close the battery compartment
cover.
charging using the supplied charger
1. Connect the 230 V mains adapter to the LiPo charger. Insert the mains adapter into a plug
socket.
2. The RED LED on the charger lights up. Insert the LiPo battery in one of the two positions on the
charger. The GREEN LED lights up. Do not force.
3. After charging for approx. 35 minutes, the battery is fully charged and the RED LED goes off.
Remove the battery from the charger.
HeLIcoPter BAtterY:
Mains adapter for charger
Spare rotor blades
4. You can monitor the controller's battery power
on the digital controller display.
Removable
helicopter battery
Beginner/advanced
mode display
Pitch trim display
Roll trim display
7