Spotlight; Setting The Time - Jacuzzi delfi pro Bedienung Und Wartung

Spotlight

T
hanks to the innovative LED digital lighting system, it is
possible to enhance the regenerating effect of the water
with an infinite combination of colours, mixed in just as many
sequences... and all with the simple press of a button.
N.B.: some models have a white light led spotlight.
Press the key "Light"
on the wall of the tub.
NOTE: some models have a white light led spotlight.
When turned on, the programme will be activated that was
in use at the last shutdown.
In the instance where you wish to select the subsequent colour,
colour cycle to the one displayed, press the key twice within a
couple of seconds:
- with the first command the spotlight goes off.
- with the second, the next colour cycle after the one that was
just turned off is activated.
To go back to initial display mode,scroll through the various
available options by repeatedly pressing the key.
The spotlight will stay on for two hours, but it can be turned
off before that by pressing the key again.
The colour combinations are regulated in terms of tones and
intensity by the built-in digital system.
Cromodream
This cycle allows you to experience the entire colour range - co-
lours appear in complimentary fashion, merging from one co-
lour to the next, providing complete satisfaction.
Sunlight
A colour trio (yellow/orange/white), with short interspersions of
sky blue and violet, reminiscent of the beneficial effects of solar
light; yellow alternated with violet uplifts mood and improves
general physical balance.
to activate the spotlight located
Relax
Formed of the following colours: blue/orange/sky blue/white;
this sequence relieves stress and encourages relaxation; the
orange hue offers warmth in this sequence composed primarily
of "cold" colours.
Steady colours
You can also choose from the following colours, which appear in
stable fashion: white, light blue, orange, yellow, green.

Setting the time

f
or correct management of water filtering and use of the energy
savings mode, the current time must be set.
Press the "Clock"
time will be displayed, the hour digit will flash, and the respecti-
ve symbol will appear on the display.
Use the "Up" and/or "Down"
the keys down for rapid change).
Then press the "Clock"
start flashing.
Proceed as described above.
Press the "Clock"
the programming mode.
Displaying the time
To display the time, press the "Clock"
NOTES
- If no key is pressed for 5 seconds, you will exit the procedure and
any changes made will not be saved.
- There is a back-up battery that keeps the time up-to-date even
when the system is powered off.
25
key for about 5 seconds. The current
keys to set the hour (Hold
key to set the minutes, which will
key again to save the set values and exit
key .