Water Filtering; Setting Filtering Cycles; Istant Clear; Water Heating - Jacuzzi delfi pro Bedienung Und Wartung

Water filtering

F
iltration, which is achieved through the combined action of the
pump and the cartridge filters, is extremely important in order
to keep the water clean and transparent and eliminate suspended
particles.
N.B.: some models are equipped with a UV light (Clearray™), which
helps disinfect and purify the water. When the filtering cycle is start-
ed, the generator starts automatically, and shuts off at the end of
the cycle.
Even if a filtration cycle is not running, when the hydromassage,
blower or even only the spotlight is activated, the filtering pump
turns on automatically (because it is presumed that someone is
in the tub and therefore there are suspended particles that could
worsen water quality). The filtering pump will continue to run for 10
minutes after the functions are turned off.
Setting the filtering cycles
To set the filtering cycle:
Press the "Filter" key for about 5 seconds. The display
shows the message Fdx, where "x" indicates the duration in hours.
Use the "Up" and/or "Down"
duration. This may be from a minimum of 0 to a maximum of 12
hours, which corresponds to constant filtering, since the cycle runs
every 12 hours in any case.
Press the "Filter" key again to confirm the selected value.
You will then go to the start time (Fs).
First set the hour and confirm with the "Filter" key. Then set
the minutes, and press the "Filter" key again to save the set va-
lues and exit programming.
When the function is on, the display will shown the respective
symbol.
NOTE: if there is a power outage, the set values will be maintained.
keys to insert the desired
26
"Instant Clear"
This special type of filtering is recommended in special situations,
such as before or after a party with friends, or to facilitate dissolu-
tion of substances used for water disinfection.
To activate this function, press and hold down the "Instant
Clear" key for 5 seconds. The display will show the message
boo.
The function lasts 45 minutes (this value cannot be changed),
but can be stopped sooner by pressing the same key. The filtra-
tion pump and the hydromassage pumps are activated accord-
ing to a particular cycle.
For details on filtering, refer to the product's installation
manual.

Water heating

T
he water in the tub is heated by an electric heater (or heat ex-
changer) located in the tub compartment; the temperature is
adjusted based on specific parameters, which are set using the
control panel.
Press the "Up" or "Down"
current memorized temperature and the respective symbol ap-
pears.
key. The display will show the