Audio System (Optional) - Jacuzzi delfi pro Bedienung Und Wartung

Audio system (optional)

USE OF THE MP3 PLAYER (not included)
Before you can use the audio system, the MP3 player must be able
to communicate with the Bluetooth® device. You must "connect"
the devices using a process known as "pairing".
Make sure the spa is powered on (display on).
Follow the instructions in the MP3 player manual on how to
perform "pairing".
NOTE: To use the audio system of the spa, select the Bluetooth® de-
vice called BT Jacuzzi". The access code is 0000.
NOTE: The Bluetooth® device of the spa is found on the side where
the control panel is located, at bottom (see figure). It turns on each
time the spa is turned on.
Once pairing is complete and the connection is established,
you can use the audio system of the spa to listen to your favour-
ite music.
NOTE: Once paired, the MP3 player and the Bluetooth® device of
the spa can connect without the need for pairing to be performed
again. Pairing is necessary if the memory settings are reset, for ex-
ample after a repair or installation (reset).
NOTE: When using the spa, we recommend that you place the MP3
player in a position that is safe from any water splashing from the
spa and to perform selections and adjust settings using the panel
located on the wall of the spa.
USING THE PANEL FOR ADJUSTMENTS
Thanks to the panel located on the wall of the spa, you can easily
control the audio system while you are comfortably in the tub.
Play/pause track
Press the key to pause the track; press it again to resume
playing.
Volume control
Press the or keys to raise or lower the volume. This ad-
justment is continuous if you hold the keys down.
NOTE: When the spa is turned off, the current volume level is saved.
When it is turned back on, this volume is used by default.
Mute
Press the key to lower the volume instantly. Press it a sec-
ond time to restore the volume gradually to the previous level.
Track selection
Press keys or to go to the next or previous track, respec-
tively.
NOTE: If you hold down the
played, forward or backwards respectively.
Please note that the first time the
beginning of the track. If you press it immediately a second time,
you will select the previous track.
Bluetooth® ( ) Key
If you have any problems with the pairing procedure, try acti-
vating the Bluetooth® device of the spa and press the
about 5 seconds.
If you have any problems with the connection, try putting the
MP3 player into "waiting for Bluetooth® connection" mode (please
see the player manual) and press the
CAUTION: If you press both the
about 5 seconds, all saved addresses will be deleted.
28
or keys, you can change the track
key is pressed, you return to the
key on the panel.
and keys at the same time for
key for