Technical Data; Guarantee Provisions - Niko 10-570 Handbuch

10-570
A list of other possible problems with their causes and solutions is given below.
Problem Cause
You hear a negative tone Programming error.
when pressing .
System is still in programming mode.
You press , but Video internal unit is not connected correctly.
nothing happens.
Two functions assigned to the button.
The image on the video Conductors V1 and V2 have been reversed.
internal unit is not clear.
Cable is unsuitable:
• cable distance is too great;
• cable is eroded;
• cable cross-section too small;
• cable is not a twisted pair cable.
The gain on the splitters is not set correctly.
No image on the video Wiring is not connected correctly:
internal unit. The other • M or P missing;
functions work OK. • V1 or V2 not connected.
The terminal resistor is not correctly configured.

6. TECHNICAL DATA

Mains supply .......................................24V DC ± 8%
Material ...............................................ABS+PC
Dimensions .........................................186 x 95 x 19mm
Weight ................................................230g
Permissible ambient temperature ..........0° to 40°C
Maximum input current ........................200mA at terminal P
Input current when OFF ........................0.4mA at terminal a; 33mA at terminal P
Colour .................................................White
Screen ................................................TFT colour screen (320 x 234 pixels, RGB)
Video signal .........................................1 Vpp, symmetric
Languages ..........................................English (standard) / Dutch / German / French / Slovak
7. WARNINGS REGARDING INSTALLATION
- The installation should be carried out by a registered installer and in compliance with the statutory regulations.
- This user manual should be presented to the user. It should be included in the electrical installation file, and it should be passed on to any new owners.
Additional copies are available on the Niko website or via the Niko support service.
- During installation, the following should be taken into account (non-exhaustive list):
- the statutory laws, standards and regulations.
- the technology currently available at the time of installation.
- this user manual, which only states general regulations and should therefore be read within the scope of each specific installation.
- the rules of proper workmanship.
8. NIKO SUPPORT
In case of doubt or for the specific exchange procedure in case of a possible defect, contact the Niko support service in Belgium at +32 3 778 90 80 or
your wholesaler/installer. Contact details and more information can be found at www.niko.eu under the "Help and advice" section.

9. GUARANTEE PROVISIONS

- The period of guarantee is four years from the date of delivery. The delivery date is the invoice date of purchase of the product by the consumer. If there
is no invoice, the date of production applies.
- The consumer is obliged to inform Niko in writing about the non-conformity, within two months after stating the defect.
- In case of a non-conformity, the consumer only has the right to a product repair or replacement free of charge, which shall be decided by Niko.
- Niko shall not be held liable for a defect or damage resulting from incorrect installation, improper or careless use, incorrect operation, transformation of
the product, maintenance that does not adhere to the maintenance instructions or an external cause, such as damage due to moisture or overvoltage.
- The compulsory regulations of the national legislation concerning the sale of consumer goods and the protection of the consumer in the countries where
Niko sells, directly or via sister companies, subsidiaries, chain stores, distributors, agents or permanent sales representatives, take priority over the
above-mentioned rules and regulations.
32
85mm (3,5") screen diagonal
Remedy
Erase the programming and programme again.
Exit programming mode.
Check the wiring.
If a call is in progress, the relay switches to open the door.
If no call is in progress, the light relay switches.
Reverse conductors V1 and V2.
Replace the current cable with a suitable cable.
Adjust the gain on the splitters with the potentiometers.
Check the wiring (see wiring diagram).
Set the terminal resistor correctly
EN