Niko 10-570 Handbuch Seite 28

10-570
3. Mounting height, centre of flush-mounting box: 150cm
4. PROGRAMMING AND CHANGING THE SETTINGS
To assign the device to a bell push button as the 1
To add the device to an installation as the 3
internal unit (see below, 4.2.3). To do this, you need the serial numbers of the other devices. The serial numbers of the internal and
external units can be found on the device and can be affixed to the installation diagram for easy programming. It is also possible
to look up the serial number in the menu (see 4.2.5, Device info.).
Changing menu functions and settings
Ta s k M e n u
1 In t er n a l C a l l
2 Co n tr o l a n d L i g h t
3 Au t om a t i c F u n c t i o n
4 In t er c o m S e t t i n g
E x it U p
1: Making an internal call
If it is not possible to make an internal call, you receive the message
"NO PRESET INTERNAL CALL".
To set the calls, see the "INSTALLER SETTINGS" menu.
In t er n a l C a l l
01 : Li v i n g r o o m
02 : Bu s i n e s s
03 : Re c e p t i o n
04 : Ro o m 0 0 1
B a ck U p
28
or 2 device, see the power supply 10-80x manual or the service set 10-870 manual.
st nd
or 4 device on a bell push button, program it in parallel (as SLAVE) with another
rd th
Press
change the settings.
.
D o w n O K
If internal calls are activated, then follow the instructions at the bottom of the screen to select
another internal unit and make a call.
D ow n O K
and use the instructions at the bottom of the screen to scroll through the menu or to
Example of a serial number
INT ERNA L CAL LS
N o Pre set Inte rnal Call
Exi t
EN