Using The Cooling Unit; Energy Saving Tips - Waeco ColdMachine 54 Bedienungsanleitung

Using the cooling unit

A
NOTICE!
Disconnect the cooling device and other power consuming devic-
es from the battery before you connect the battery to a quick
charging device. Overvoltage can damage the electronics of the
device.
For safety reasons the cooling unit is equipped with an electronic system to
prevent polarity reversal. This protects the cooling unit when it is connected
to a battery.
Connecting to a 230 V mains supply
!
WARNING!
 Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
 If you are operating your cooling device on board a boat with
a mains connection of 230 V from the land, you must install
a residual current circuit breaker between the 230 V mains
supply and the cooling device.
Seek advice from a trained technician.
➤ To operate the cooling unit from the 230 V mains, use the WAECO
rectifier
– CoolPower EPS100 for devices with Bd-35F compressor
(50/80/CS/CS series),
– CoolPower MPS35 for devices with Bd-35F compressor
(50/80/CS/CS series),
– CoolPower MPS50 for devices with Bd-50F compressor (90 series).
I
NOTE
The output voltage of the described rectifier is 24 V. Please
remember this when connecting other consumers at a later time.
7 Using the cooling unit
7.1

Energy saving tips

 Choose a well ventilated installation location which is protected from
direct sunlight.
 Allow hot food to cool down first before placing it in the device.
 Do not open the refrigerated container more often than necessary.
46
Coldmachine
EN