Functional Check - Getinge 607 Montage-Und Installationsanleitung

Process running
S-606dekal
Process completed
8
Installation

Functional check

• Check that the wash disinfector is connected to the right voltage, as
indicated ion the rating plate.
• Open the water valves and switch on the operating switch. The message
"Ready for use. Select program" shall appear in the display window.
• If the machine is provided with metering of the cleaning agent: Presss
and check that the lamp in the button lights.
• Check that the incoming hot water is at the right temperature. The tempera-
ture shall be in the range 45 - 60°C.
• Start the Intensive program with the machine empty (select program on the
panel, then start with foot pedal), and check that:
- the yellow lamp at L lights,
- the temperature increases continuously until the cooling phase starts,
- the pause for heating does not exceed ca. 10 minutes,
- the temperature reaches 90 °C,
- the green lamp at M lights, and the display window shows Program
ready.
&=q
• If the machine has a system for the cleaning agent and/or de-scaling agent:
Measure out the agent in a measuring glass. Ensure that the suction hose is
filled with the agent. Start a normal programme, and check that the
disinfector consumes the right quantity. For cleaning agent, the quantity/
programme is usually ca. 20 ml and for de-scaling agent is ca. 1.5 - 4.0 ml
(follow the supplier's recommendations).
• If the machine is equipped with a peripheral washing program:
v v
Press button v v and check that the peripheral washing programme is v
running.
N.B.the peripheral washing programme can not be started with the foot pedal.
• Check for the absence of water leaks. Tighten the connections and pipe
couplings, if necessary.
Edition 040210 5013246-00