Abicor Binzel ABIMIG A 255 Betriebsanleitung Seite 39

®
ABIMIG
8.1 Replacing the torch neck
9 Disposal
DANGER
Risk of burns
Risk of burns from hot coolant and hot surfaces.
• Switch off the coolant recirculator before starting maintenance, servicing,
assembly, disassembly or repair work.
• Allow the welding torches to cool down.
• Wear the correct protective gloves.
NOTICE
• The specified maintenance intervals are guidance values and refer to
single-shift operation.
• Maintenance and cleaning work may only be carried out by qualified
personnel (in Germany see TRBS 1203).
• Check the coolant hose, seals and connectors for damage or leaks and
replace if necessary.
• Check and clean the power contact surfaces on the torch neck and torch
neck seat.
• Always wear your personal protective equipment when performing
maintenance and cleaning work.
• Remove any adhering weld spatter.
• Ensure that all threaded fittings are tight.
 5.1 Setting up the torch on page EN-7
NOTICE
• Do not dispose of the device with household waste.
• For disposal, observe the local regulations, laws, provisions, standards
and guidelines.
9 Disposal
EN - 19