Abicor Binzel ABIMIG A 255 Betriebsanleitung Seite 33

®
ABIMIG
®
4 ABIMIG A T LW:
Slide in the torch neck liner and shorten it at the end free of the retaining
nipple until it flexibly protrudes 2 mm from the retaining nipple.
®
ABIMIG W T:
Cut off the torch neck liner (2) with an excess length of 12 mm from the
current contact area (3) free of burrs.
5 Deburr the cutting edges.
6 Where applicable, remove the sealing plug and screw the torch neck (1)
into the torch seat on the torch handle.
NOTICE
• Ensure that the current contact areas on the torch neck and torch neck
seat are clean.
®
• For ABIMIG W T, grease the O-rings with silicone-free lubricant
(192.0078). This makes it easier to insert the torch neck and extends the
service life of the O-rings.
For welding tasks for which a continuous wire guide is essential, the insulating
bush in the interior of the torch neck seat can be screwed out using a flat head
screwdriver (width approx. 10 mm).
ABICOR BINZEL offers an optional insulating bush for through-hole wire
guides.
5 Putting into operation
EN - 13