Abicor Binzel ABIMIG A 255 Betriebsanleitung Seite 32

5 Putting into operation
5.4.3 Torch neck liner
EN - 12
6 Maintain the pressure on these and tighten the nut (6).
7 Introduce the central connector (7) together with the long PA liner through
the central socket into the wire feeder.
8 Mark the PA liner directly in front of the rolls and disconnect the central
connector again (7).
9 Cut off the PA liner with the ABICOR BINZEL cutter where marked.
10Sharpen the start of the PA liner to an angle of 40° using the
ABICOR BINZEL sharpener.
®
Only for ABIMIG A T LW/ABIMIG
1
4
1 Torch neck
2 Torch neck liner
Fig. 4 Torch neck liner
1 Unscrew the torch neck (1) from the torch handle and optionally insert the
sealing plug into the torch handle.
2 Grind the torch neck liner (2) to an angle of 40° on the contact tip side
(stripped side).
3 Introduce the torch neck liner (2) with the stripped side into the torch neck
until the end stop at the contact tip (4).
®
W T change neck torches.
3 Current contact area
ABIMIG
2
12
3
2
2
3
4 Contact tip
®