Designated Use - Abicor Binzel ABIMIG A 255 Betriebsanleitung

®
ABIMIG
1 Identification
1.1 CE marking
2 Safety

2.1 Designated use

2.2 Classification of the warnings
MIG/MAG manual welding torches are used to safely weld low and high-
alloy materials. They consist of the torch neck with equipment parts and wear
parts, the torch handle and the cable assembly with a central connection. They
conform to EN 60 974-7 and are not considered devices that independently
fulfil functions. 
Arc welding can only be carried out in connection with a welding power
source.
This device fulfils the requirements of the valid EU directives.
The conformity is confirmed by the CE marking on the
device.
The attached safety instructions must be observed.
• The device described in these instructions may be used only for the
purpose and in the manner described in these instructions. In doing so,
observe the operating, maintenance and servicing conditions.
• Any other use is considered improper.
• Unauthorised modifications or changes to enhance the performance are
not permitted.
The warnings used in the operating instructions are divided into four different
levels and shown prior to potentially dangerous work steps. Arranged in
descending order of importance, they have the following meanings:
DANGER
Describes an imminent threatening danger. If not avoided, this will result in
fatal or extremely critical injuries.
WARNING
Describes a potentially dangerous situation. If not avoided, this may result in
serious injuries.
1 Identification
EN - 3