Forest-Master FM8 series Bedienungsanleitung Seite 14

Ram Stop
IMPORTANT: Ensure the motor is switched off and only
use the operating lever to hold the ram in position
when adjusting the ram stop.
14
RAM STOP
Loosen the knob on the ram stop so
that it is free to slide on the bar.
Operate the log splitter to move the
ram forward to the required length.
Holding the operating lever in place
to ensure the ram does not return,
position the ram stop against the
front of the splitter and tighten
using the knob. The ram stop can
be adjusted by simply unscrewing
the knob and sliding along the
cradle bar, the ram may need to
be moved forward depending on
the length of log you wish to split.
The operating lever must be held
in place when unscrewing the ram
stop or the ram will return.
FM8(R/D/T) & FM10(R/D/T)