Whale Bilge IC series Montagehandbuch Und Bedienungsanleitung Seite 4

3. LIST OF CONTENTS AND LIST OF DIAGRAMS
1. TYPICAL INSTALLATION
2. SPECIFICATION
3. CONTENTS AND DIAGRAMS
4. PRINCIPLES OF OPERATION
5. TO THE USER
6. TO THE FITTER
7. APPLICATION
8. WARNINGS
9. PARTS LIST
10. OPTIONAL EXTRAS
11. INSTALLATION
LIST OF DIAGRAMS:
Fig 1 Gulper® IC - Typical Installation As A Remote Mounting Bilge Pump For Use With
Whale Strainer IC
Fig 2 Pump Orientation
Fig 3 Gulper® IC Installation
Fig 4 Install P Clamp
Fig 5 Strainer IC Connection
Fig 6 Strainer IC Connection
Fig 7 Wiring Gulper® IC To Strainer IC
Fig 8 Connecting Switching Cable Through Bulkhead
Fig 9 Connect Deutsch® Connectors
Fig 10 Securing Pipework
Fig 11 Strainer IC Operation Test
Fig 12 For Cleaning - Detach Top Cover Of Strainer IC
Fig 13 For Cleaning - Unscrew Valve Housing
4. PRINCIPALS OF OPERATION
IC - Intelligent Control Technology
At the heart of every Whale® IC product lies innovative electronic control circuitry built in. This
enables IC sensor accessories to communicate directly with IC pumps to control their performance.
These accessories send signals to built-in intelligent software which then control the pumps to react
as required.
Gulper® IC
The Gulper® IC fully automatic self-priming pump is designed as a remote mounting bilge pump.
Output capacity depends on installation and operating conditions.
REMOTE MOUNTED BILGE APPLICATION
Save time and money by reducing four separate components to one pre-wired system. Remote
mounting automatic Gulper® IC receives signals from Strainer IC and switches on and off automat-
ically (See Fig 1). Suitable for a primary bilge pump for boats smaller than 12 metres/39.4 ft
(designed to ISO15083), or as a secondary bilge pump on any recreational marine vessel.
5. TO THE USER
Read the following instructions carefully.
6. TO THE FITTER
Check that the product is suitable for the intended application, follow these installation instructions
and ensure all relevant personnel read the points listed below. Also ensure that these operating
instructions are passed on to the end user.
12. PLUMBING
13. INSTRUCTIONS FOR USE
14. MAINTENANCE
15. HELPFUL HINTS
16. TROUBLE SHOOTING
17. WINTERIZING
18. SERVICE SUPPORT DETAILS
19. PATENTS/ TRADEMARKS
20. WARRANTY STATEMENT
21. EU DECLARATION OF
CONFORMITY, APPROVALS
4