Ods-L100E - Sony ODS-series Handbuch

• STATUS indicator
Lit green: The drive unit can be replaced (i.e., drive is
offline and drive power is off).
Lit red:
• An alarm occurred (alarm code other than 00-000).
• Library and drive units are not communicating
normally.
• The drive unit power supply was forcibly turned off
(POWER indicator also turned off) due to a library
power supply fan fault.
Slow blinking green (1-sec. interval): The drive is
initializing.
Rapid blinking green (0.25-sec. interval): Firmware
update in progress.
Off: Normal status.
m OUT 1 (unit interconnection) connector
Connect to the IN 1 connector of the master unit
(ODS-L30M) or another extension unit (ODS-L60E/
L100E) using unit interconnection cable 1 (supplied with
the extension unit).

ODS-L100E

Front panel
This is identical to the front panel of the ODS-L60E (see
page 47).
Rear panel
a OUT 1 (unit interconnection) connector
Connect to the IN 1 connector of the master unit
(ODS-L30M) or another extension unit (ODS-L60E/
L100E) using unit interconnection cable 1 (supplied with
the extension unit).
50
Name and Function of Parts
n OUT 2 (unit interconnection) connector
Connect to the IN 2 connector of the master unit
(ODS-L30M) or another extension unit (ODS-L60E/
L100E) using unit interconnection cable 2 (supplied with
the extension unit).
o IN 2 (unit interconnection) connector
Connect to the OUT 2 connector of the master unit
(ODS-L30M) or another extension unit (ODS-L60E/
L100E) using unit interconnection cable 2 (supplied with
the extension unit).
p IN 1 (unit interconnection) connector
Connect to the OUT 1 connector of the master unit
(ODS-L30M) or another extension unit (ODS-L60E/
L100E) using unit interconnection cable 1 (supplied with
the extension unit).
q Cable clamper
b OUT 2 (unit interconnection) connector
Connect to the IN 2 connector of the master unit
(ODS-L30M) or another extension unit (ODS-L60E/
L100E) using unit interconnection cable 2 (supplied with
the extension unit).