Notes On Handling; Cartridge Memory; Write-Protecting Media - Sony ODS-series Handbuch

• When you reformat write-once media, the previous
maximum number of files that can be created (480,000
for ODC3300R cartridges, 60,000 or 240,000 for other
cartridges) will carry over. However, you can reselect
the maximum number of files that can be created when
you reformat rewritable media.
• For cartridges other than the ODC3300R, if you select
240,000 as the maximum number of files that can be
created during formatting, the rate of successful repair
for the file repair function will be lower than when
60,000 is selected.
• Read-only cartridges cannot be formatted on the ODS-
D280F.
• Do not insert ODC3300R cartridges into the ODS-D77F.
Inserting a cartridge may damage the unit.

Notes on Handling

Handling
The cartridge houses multiple discs in a shell, and is
designed to allow handling free of risk from dust or
fingerprints. However, if the cartridge is subjected to a
severe shock, for example by dropping it, this can result in
damage or scratching of the discs. If a disc is scratched, it
may be impossible to write data, or to read the data written
on the disc. The cartridge should be handled and stored
carefully.
• Do not remove any discs from the cartridge.
• Do not disassemble the cartridge.
• If the disc order in a cartridge is changed, or other discs
are substituted, the cartridge will no longer be
recognized by the unit and cannot be used.
• The supplied adhesive labels are recommended for
indexing cartridges. Apply the label in the correct
position.
Storage
• Do not store cartridges where they may be subjected to
direct sunlight, or in other places where the temperature
or humidity is high.
• Do not leave cartridges where dust may be able to gain
ingress.
• Store cartridges in their cases.
Care of the cartridge
• Remove dust and dirt on the outside of a cartridge using
a soft dry cloth.
• If condensation forms, allow ample time to dry before
use.

Cartridge Memory

The cartridge includes cartridge memory, which enables
contactless communication with this unit.
Basic information about the cartridge is written in
cartridge memory.
52
Handling Media
Using the application software will enable the user-data to
be written/read in the future.
Cartridge memory position

Write-Protecting Media

To prevent erasing contents of recorded media
accidentally, slide the Write protect tab on the bottom of
the cartridge (rear of label side) in the direction of the
arrow, as shown in the following figure.
Bottom of the cartridge Write protect tab
Write protect tab settings
Writing
enabled
You can also perform the write-protect settings for media
from the host application.
If either the write-protect tab or the host application is set
to prohibit writing, the media will remain in the write-
protected state.
Writing
disabled