Sony ODS-series Handbuch Seite 56

5
Use the J and j buttons to select [IPv4 Setting], and
press the ENTER button.
The following screen appears. An asterisk (*)
indicates the current setting. To configure the IPv4
address, this setting must be set to [Enabled]. If the
setting is already set to [Enabled], proceed to step 8.
6
Press the ENTER button to change the setting.
The selection screen (i.e., screen with the cursor (>))
appears. You can change the setting in this screen.
7
Use the J and j buttons to select [Enabled], and press
the ENTER button.
The confirmation screen (i.e., screen without the
cursor (>)) appears.
8
Check that [Enabled] is selected, and press the j
button.
The following screen appears.
9
Press the ENTER button to display the selection
screen.
10
To use a static IP address, use the J and j buttons to
select [Static], and press the ENTER button.
Note
To use the DHCP, use the J and j buttons to select
[Auto], press the ENTER button, and then proceed to
step 17.
56
Configuring the Network
11
Press the j button.
The following screen appears.
12
Press the ENTER button.
The first digit of the IP address blinks, indicating that
it can be changed.
13
Enter the IP address.
Use the K and k buttons to move the cursor, and use
the J and j buttons to change the values.
14
Press the ENTER button after entering the address to
confirm it.
15
Press the j button to display [IPv4 Netmask], and
configure the subnet mask using the same method as
the IP address.
16
Press the j button to display [IPv4 Gateway], and
configure the default gateway using the same method.
17
Press the j button.
[IPv4 DNS] appears.
18
To configure the DNS address, select [Static].
If the current setting is [Auto], display the selection
screen using the ENTER button, use the J and j
buttons to select [Static], and then press the ENTER
button to confirm.