Step 4: Secure The Cords; Step 5: Turn On The Display And Computer - Sony SDM-series Bedienungsanleitung

Step 4: Secure the cords

x Fixed stand
Be sure that the cords and cables are fed through the stand hole as
illustrated.
The illustration of the back of the display shown here is that of
the SDM-S76D.
The same applies for the other models.
x Height adjustable stand
Draw the cords and cables through the cable holder as illustrated.
Note
When bounding the cords and cables, be sure to loosen them a little. If
they get pulled hard they may come off from the connectors or plugs as
you adjust the screen angle. If you stretch the cords and cables too hard
they may get damaged.
Step 5: Turn on the display and
computer
1
Press the 1 (power) switch located on the front
right of the display.
The 1 (power) indicator lights up in green.
2
Turn on the computer.
The installation of your display is complete. If necessary, use the
display's controls to adjust the picture.
If no picture appears on your screen
• Check that the power cord and the video signal cable are
properly connected.
• If NO INPUT SIGNAL appears on the screen:
The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
• If CABLE DISCONNECTED appears on the screen:
Check that the video signal cable is properly connected.
• If OUT OF RANGE appears on the screen:
Reconnect the old display. Then adjust the computer's graphics
board within the following ranges.
Horizontal
frequency
Vertical
frequency
Resolution
For more information about the on-screen messages, see "Trouble
symptoms and remedies" on page 18.
8
(GB)
lights in green
Analog RGB Digital RGB
(SDM-S76D/
SDM-S96D/
SDM-V76D/
SDM-V96D/
SDM-S76F/
SDM-S96F only)
28–80 kHz 28–64 kHz
56–75 Hz 60 Hz
1280 × 1024 or less 1280 × 1024 or less