Adjusting The Backlight (Backlight) - Sony SDM-series Bedienungsanleitung

8 MENU POSITION
(page 15)
Select the MENU
POSITION to change the on-
screen menu position.
9 INPUT SENSING
(page 15) (SDM-S76D/
SDM-S96D/SDM-V76D/
SDM-V96D/SDM-S76F/
SDM-S96F only)
The display automatically
detects an input signal to an
input terminal, and changes
the input automatically
before the display goes into
the power saving mode.
0 LANGUAGE (page 15)
Select LANGUAGE to
change the language used on
menus or messages.
qa Other menus (page 15)
Set the following menu
items.
• RESET 0
• MENU LOCK
x Using the MENU, m/M, and OK buttons
1
Display the main menu.
Press the MENU button to display the main menu on your
screen.
MENU
2
Select the menu you want to adjust.
Press the m/M buttons to display the desired menu. Press the
OK button to select the menu item.
,
M E N U P O S T O N I I
1 2 8 0 x 1 0 2 4 / 6 0 H z
E X I T
I NP U T S E N S I NG
A U T O ON
A U T O O F F
1 2 8 0 x 1 0 2 4 / 6 0 H z
E X I T
L A N G UAG E
E N G L I S H
F R A N Ç A I S
D E U T S C H
E S P A Ñ O L
I T A L I A N O
1 2 8 0 x 1 0 2 4 / 6 0 H z
E X I T
R E S E T
O K
C A N C E L
1 2 8 0 x 1 0 2 4 / 6 0 H z
E X I T
INPUT
OK
11
3
Adjust the menu.
Press the m/M buttons to make the adjustment, then press the
OK button.
When you press the OK button, the setting is stored, then the
display returns to the previous menu.
4
Close the menu.
Press the MENU button once to return to normal viewing. If
no buttons are pressed, the menu closes automatically after
about 45 seconds.
MENU
x Resetting the adjustments
You can reset the adjustments using the RESET menu. See
page 15 for more information on resetting the adjustments.
x Controlling the display by computer
Press the MENU button down for at least 5 seconds. You will see
an on-screen message indicating the current setting. After 3
seconds the DDC/CI setting is switched on or off, as shown
below.
On-screen messages
(Appear for a while)
DDC-CI : ON
(default setting)
DDC-CI : OFF
Note
This function applies only to computers that support the DDC/CI
(Display Data Channel Command Interface) function.
Adjusting the backlight
(BACKLIGHT)
Note
The backlight cannot be adjusted when the ECO mode is set to
HIGH, MIDDLE, or LOW (page 10).
If the screen is too bright, adjust the backlight and make the screen
easier to see.
1
Press the MENU button.
The main menu appears on the screen.
2
Press the m/M buttons to select
and press the OK button.
The BACKLIGHT menu appears on the screen.
(GB)
INPUT
OK
,
Allows the computer to control
menu settings.
Does not allow the computer to
control menu settings.
(BACKLIGHT)