Adjusting The Tilt; Adjusting The Height (Sdm-S76F/Sdm-S96F Only); Selecting The Input Signal (Input Button) (Sdm-S76D/Sdm-S96D/Sdm-V76D/ Sdm-V96D/Sdm-S76F/Sdm-S96F Only) - Sony SDM-series Bedienungsanleitung

No need for specific drivers
The display complies with the "DDC" Plug & Play standard and
automatically detects all the display's information. No specific driver
needs to be installed to the computer.
The first time you turn on your computer after connecting the display, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play display is automatically selected so that you
can use this display.
The vertical frequency turns to 60 Hz.
Since flickers are unobtrusive on the display, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.

Adjusting the tilt

This display can be adjusted within the angles shown below.
Hold both sides of the LCD panel, then adjust screen
angles.
approx. 5°
To use the display comfortably
This display is designed so that you can set it up at a comfortable
viewing angle. Adjust the viewing angle of your display
according to the height of the desk and chair, and so that light is
not reflected from the screen to your eyes.
Note
When adjusting the screen tilt, make sure not to knock or drop the display
off the desk.
approx. 20°
9
Adjusting the height
(SDM-S76F/SDM-S96F only)
When you use the height adjustable stand, the height adjust is also
available as below.
Hold both sides of the LCD panel, then adjust screen
height.
To use the display comfortably
Adjust the viewing angle of your display according to the height
of your desk and chair, so that light is not reflected from the screen
to your eyes.
Notes
• When adjusting the screen's angle, be sure not to crash it against any
objects around the display.
• Do not put any objects under the display when you adjust the height of
stand. It may get damaged by accident.
Selecting the input signal
(INPUT button) (SDM-S76D/SDM-S96D/SDM-
V76D/SDM-V96D/SDM-S76F/SDM-S96F only)
Press the INPUT button.
The input signal change each time you press this button.
On-screen message
(Appears about 5 seconds on
the upper left corner.)
INPUT1 : DVI-D
INPUT2 : HD15
(GB)
approx. 110 mm
11
(4 / inches)
32
INPUT
OK
Input signal configuration
DVI-D input connector
(digital RGB) for INPUT1
HD15 input connector
(analog RGB) for INPUT2