Step 3: Connect The Power Cord; Step 4: Secure The Cords; Step 5: Turn On The Monitor And Computer - Sony SDM-G76X Handbuch

x Connect the audio cord
Connect the supplied audio cord to the monitor's
corresponding audio input jack.
Using the monitor's speakers or headphones, you can listen to
sound from your computer or other audio equipment connected to
the monitor's audio input jacks.
For more information, see "Controlling the volume" on page 18.
to audio output of the
computer or other audio
equipment

Step 3: Connect the power cord

With the monitor and computer switched off, first connect the
power cord to the monitor, then connect it to a power outlet.
to AC IN
to a power outlet
power cord (supplied)
to the audio input
audio cord (supplied)

Step 4: Secure the cords

1 Bundle the cables and cords.
Using the supplied cord strap, bundle the cables and cords.
The illustration of the back of the monitor shown here
is that of the SDM-G76X.
The same applies for the other models.
Step 5: Turn on the monitor and
computer
Press the 1 (power) switch.
The 1 (power) indicator of the monitor lights up in green.
Turn on the computer.
The installation of your monitor is complete. If necessary, use the
monitor's controls to adjust the picture.
• If no picture appears on your screen
Check that the power cord and the video signal cable are
properly connected.
• If NO INPUT SIGNAL appears on the screen:
The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
• If CABLE DISCONNECTED appears on the screen:
Check that the video signal cable is properly connected.
• If OUT OF RANGE appears on the screen:
Reconnect the old monitor. Then adjust the computer's
graphics board within the following ranges.
9
(GB)
Cord strap (supplied)