Troubleshooting - Steinbach Speedclean 75 Bedienungsanleitung

EN

Troubleshooting

Malfunction Cause
Pressure Dirty filter bed
gauge has
reading over 1
bar
Pressure is too Hair and lint strainer
low basket is dirty; Pump
gets too little water
Air in the pump Poor seal on the in-
take side
pump.
Leaking filter Seal Defective
Pump does not Not plugged in
run
G.F.C.I/ or main cir-
cuit breaker tripped
Pump motor defecti-
ve
Sand in Pool If the sand is newly
replaced, the under-
sized grains are still
present
Sand in
Valve (from
wash)
Separation wall in fil-
ter is improperly in-
stalled
Filter bottom strainer
is damaged
Air in system
Important note:
On the pump label of your filter pump is a serial number (B/...) indi-
cated and on the tank cover is a lot number shown (read from above
on handle), please provide this data in the case of a complaint.
Steinbach VertriebsgmbH,
Aistingerstrasse 2, 4311 Schwertberg, Österreich
FR/IT/CZ/HU/HR/SK/SLO/RO/BG/TR: +43 (0) 7262 / 61431-0
e-mail: service@steinbach.at
www.steinbach.at
Sandfilter Speedclean 75/50 | 2015_V1
Solution
Backwash the filter (posi-
tion 4)
Clean the hair and lint
strainer; check the suction
line and the water level
Tighten hose clamps and
of the connecting fittings.
Check the seal, replace if
needed
Check the socket and
power cord
Switch on the breaker (if it
is immediately tripped
again, there is a defect in
pump or controls)
Replace the entire pump
Backwash several times
until the backwash water
is clear (position 4)
Central Purge into drainpipe for
back- 30 seconds (position 6)
Check the separation wall
for proper positioning
Replace the filter bottom
strainer
Loosen, but do not re-
move, the transparency
cover on the filter tank to
allow any trapped air to
escape. Tighten the cover
once all of the air has es-
caped
Page 11 of 64