Rs232 Control; Operation By Showme Button - Kindermann QuickSelect 3.0 Installationsanleitung Und Bedienungsanleitung

Enter RS232 commands and read out answers:
7

RS232 control

.
The free configuration software or a media control also permits controlling the entire QuickSelect
system via the RS232 connection in all details.
The HDBaseT-Bus can also transmit RS232-control commands for controlling further devices such as
projectors and display, bidirectionally (pass through). Connect e. g. the RS232-interface of the media
control simply to a RS232-terminal.
The detailed RS232-protocol and a driver for Neets controls can be found online at:
shop.kindermann.de/evp/webshop/navigation_Path/7447000400.html

8. Operation by ShowMe button

Every QuickSelect has connections for three external buttons with status LED at the rear so that the
user can select every input separately as well, e.g. in a table connection field. Install the QuickSelect
under the table with the mounting brackets so that the label points up; wire the connection field with
the QuickSelect accordingly.
e. g. customised module carrier (no. 7449 000318)
The rear ShowMe-connection acts like the integrated ShowMe-button. If only one source is connected,
the active input is automatically chosen when pushing the ShowMe button. Otherwise, the inputs are
switched through cyclically.
You can use these text fields to send RS232 commands and read the
response of the QuickSelect 3.0 chain. All values are displayed in HEX.
The commands of the respective control commands are automatically
entered under RS232-TxD (Hex) and may be copied, e. g. for the purpose
of driver creation for media controls. The same applies to the respective
device feedbacks.
Note: ALL commands entered under RS232-TxD are always sent in
sequence. If only a single command is to be sent, please clear the field
first and enter the individual command.
LED
GND
KEY
NC
+ NO -
C
29