Automatic Device Address Awarding (Address "99"); Reading And Saving Edid Information Of Playback Devices - Kindermann QuickSelect 3.0 Installationsanleitung Und Bedienungsanleitung

5.3 Automatic device address awarding (address "99")

Alternatively to manual address awarding according to 5.2 the addresses of all units can awarded
automatically. Make sure that in this case all BCD switches must be kept in their default position "99".
We recommend using the free configuration software. If the software is not at hand proceed as follows:
Plug all mains units except for the first one in the chain into the mains socket. Plug the supplied Quick-
Setup jumper into the socket "VGA" at the rear of the first device. Now plug the mains unit of the first
device into the mains socket. During the address awarding the LEDs of the signal inputs on the front
light-up 3x several times. Remove the Quick-setup jumper.
Producing your own Quick-setup jumper: Connect the KEY and GND contacts of an enclosed 3-pin screw/
plug connection terminal with a wire jumper.

5.4 Reading and saving EDID information of playback devices

The QuickSelect uses AUTO EDID to read the resolutions that can be presented for the first playback
device in the chain via the HDMI connection and saves them in all QuickSelects. We recommend using
the free configuration software. If the software is not at hand proceed as follows:
Plug all mains units except for the first one in the chain into the mains socket. Plug the supplied Quick-
Setup jumper into the socket "HDMI2" at the rear of the first device. Now plug the mains unit of the first
device into the mains socket. During the EDID reading and writing process the LEDs of the signal inputs
on the front light-up 3x several times. Remove the Quick-setup jumper.
The EDID information is now saved in all HDMI signal inputs of the devices. The EDID information is used
to automatically adjust the resolution of the graphics card of the signal encoder (e. g. laptop) to the
resolution of the playback device (e. g. projector).
Note: If the HDBaseT Link-out on the last QuickSelect in the chain is used for signal outpout, then the EDID
of the display device must be read and saved using the free configuration software.
21