Herunterladen Inhalt Inhalt Diese Seite drucken

Setting And Starting A Programme; Cancelling The Programme - Electrolux GA60SLI222 Benutzerinformation

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

70 www.electrolux.com
• If the display shows the salt mes-
sage, fill the salt container.
• If the display shows the rinse aid
message, fill the rinse aid dispenser.
3. Load the baskets.
7.1 Using the detergent
A
7.2 Setting and starting a
programme
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance.
3. Close the appliance door.
4. Set the programme and options
5. Press the OK, the programme starts.
• If the salt container or the rinse aid
dispenser need refilling, the related
messages will show in the display.
In this case the programme will not
start. Press again OK to start the
programme.
Starting a programme with delay
start
1. Set the programme. You can also set
the applicable options.
2. Set the delay start.
3. Press OK, the countdown starts.
• If the salt container or the rinse aid
dispenser need refilling, the related
messages will show in the display.
In this case the programme will not
start. Press again OK to start the
programme.
B
30
A
20
+
-
C
4. Add the detergent.
5. Set and start the correct programme
for the type of load and the degree of
soil.
1.
Press the release button (B) to open
the lid (C).
2.
Put the detergent in the compartment
(A) .
3.
If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4.
If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
When the countdown is completed, the
programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while
the countdown operates
1. Press the cancel touchpad.
2. The display shows a message. Follow
the instructions to confirm the cancel-
ling of the delay start.
3. When the delay start is cancelled,
press OK to start the set programme.

Cancelling the programme

1. Press the cancel touchpad.
2. The display shows a message. Follow
the instructions to confirm the cancel-
ling of the programme.
Make sure that there is detergent
in the detergent dispenser before
you start a new programme.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis