Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SAFETY INSTRUCTIONS
Installation precautions
•
This unit is designed to operate on 14,4 V DC power supply. If your vehicle does not have this
system, a voltage inverter is required. The device also requires connecting to negative of the
car.
•
Choose the mounting location where the unit will not interfere with the normal driving function
of the driver. Install the unit where it does not get in the driver's way and cannot injure the
passenger if there is a sudden stop. DO NOT install the unit or any cable in a location where:
◦
it may obstruct the steering wheel and gearshift lever operations,
◦
it may obstruct the operation of safety devices such as air bags
◦
it may obstruct visibility
◦
there is not enough ventilation provided
•
there is not enough ventilation provided
•
Avoid installing the unit where it would be subject to high temperature, such as from direct
sunlight, hot air, or a heater, or where it would be subject to dust, dirt or excessive vibration.
Do not expose this equipment to rain or moisture nor use near strong magnetic fields. Do not
handle this appliance with wet hands.
•
Make sure all the connections are executed in a proper manner. Reversed connection will
cause short circuit and damage.
•
If installation angle exceeds 30 from horizontal, the unit might not give its optimum performance.
•
Before finally installing the unit, connect the wiring temporarily and make sure it is all connected
up properly and the unit and the system work properly.
•
If the fuse blows, check the power connection and replace the fuse with one of the same
specified rating. If the fusei blows frequently, consult an authorized service point for check-up/
repair.
•
It is recommended to connect speakers with impedance of 4 Ω.
•
To prevent short circuits, cover the terminals of the UNUSED leads with insulating tape.
•
Make sure that the ignition is off before connecting the device.
•
Make sure to connect the yellow and red power supply cables after all other cables are already
connected.
•
The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.
•
At the time of installation, be sure to fix all wires (wires both from this unit and from the car itself)
in a way that any wires cannot come into contact with heat sinks on the rear and side of the unit.
•
Installation illustrations show a typical installation. However, you should make adjustments
corresponding to your specific car. If you have any questions or require information regarding
installation kits, consult your car dealer.
•
If you are not sure how to install this unit correctly, have it installed by a qualified technician.
Producer does not claim liability of incorrect mounting/installation nor for inappropriate handling
and use disregarding this user's manual.
•
When mounting the unit, be sure to use the screws provided, as instructed. If other screws are
used, parts could become loose or damaged. Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts can cause malfunctions.
•
When tightening screws or bolts, be careful not to pinch any connection cord.
•
Make sure not to block the ventilation outlets.
•
DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will
be seriously damaged.
•
BEFORE connecting the speaker leads, check the speaker wiring in your car.
•
Consult with your nearest dealer if installation requires the drilling of holes or other modifications
of the vehicle. In case of any doubts concerning place of installation, contact your vehicle's
dealer. Before drilling the holes in vehicle's body, make sure it will not damage any electrical
cables or other components. During installation keep in mind, that any loose parts may pose
danger in case of an accident – make sure to install every piece properly to ensure safety.
•
Do not remove the housing/disassemble the device. The device has no user-serviceable parts
Owner's manual
EN
17
Werbung
Inhaltsverzeichnis
