GUTMANN EM 22 Montageanleitung Seite 12

en
Load of all cooking areas max. 8.3 kW
Load of the oven max. 3.9 kW
Gas Cooktops
Load of one cooking area max. 3.9 kW
Load of all cooking areas max. 11.3 kW
Subject to technical changes!
Installation Instructions
Top connection
1. Prepare appropriate ventilation guide in the
ceiling.
2. Prepare a cut-out on the bottom of the
hanging cabinet/interim ceiling. Measure the
hood to obtain the proper dimensions.
To achieve optimum vapor removal, you must
place the range hood in such a manner that
it is centered above the cooking surface! (use
a perpendicular for assistance and to
determine the exact location).
Figure: EM 31
3. Use the hanging locations on the hood
body to determine the locations of the holes
in the interim ceiling/bottom of the cabinet and
drill them accordingly. Any dimensions not
provided depend on the model and must be
measured on the hood itself.
Make sure you are in compliance with the
minimum required clearance between the
cooking surface and the bottom edge of the
range hood.
4. Align the exhaust air hose to achieve the
appropriate length and subsequently mount
same to the exhaust air connecting piece with
the hose clamp. Make sure that the exhaust
air hose is installed without any kinks!
Connect to electricity.
Figure EM 22
5. Drill holes and install the respective dowel
so that it is flush. Now push the hood parallel
into the cut-out opening and mount it into
place with appropriate screws. Align the range
hood (verify installation measurements) and
tighten the screws.