Operation - Lightmaxx Vector Spot 150 Bedienungsanleitung

Operation:

All connections of the device should be made before switching on. Use only high-quality cables
that are as short as possible for the connections.
Configuration of the DMX plugs:
Resistance 120 ohm 1/4w between pin 2 (DMX-) andf pin 3 (DMX+) of the last fixture.
Operating Mode DMX:
Connect the DMX input of your device to the DMX output of your DMX controller, your DMX
software or the DMX output of a device already in your DMX chain. Always use DMX cable with a
110 Ohm resistor for this connection. Address the device according to your DMX configuration. The
device has a DMX mode with 10, 12, 14 or 16 channels, which is based on the following functions:
18