Safety Precautions - Daikin R410A SPLIT-Serie Installationsanleitung

INSTALLATION MANUAL
Tills mannal provides the procedures of installation to ensure a safe and good standard of operation for the air conditioner unit.
Special adjustment may be necessary to suit local requirement.
Before using your air conditioner, please read this instruction Ulallllal carefully and keep it for future reference.
Tills appliance is intended to be used
by
expert or trained users in shops,
ill
light industry and
011
farms, or for commercial use
by
lay
persons.
Tills appliance
is
1I0t
intended for use by persons, including children, with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use oCtile appliance
by
a person responsible
for their safety.
Children shOlild be supervised to ensure that they do not play with the appliance.
SAFETY PRECAUTIONS
Lh WARNING
• Installation and maintenance should be perfonned by qualified
persons who are familiar with local code and regulation, and
experienced with this type of appliance.
• All field wiring must be installed in accordance with the national
wiring regulation.
• Ensure that the rated voltage of the unit corresponds to that of
the name plate before commencing wiring work according to
the wiring diagram.
• The Imit must be GROUNDED to prevent possible hazard due
to insulation failure.
• All electrical wiring must not touch the water piping or any
moving parts of the fan motors.
• Confinn that the unit has been switched OFF before installing
or servicing the unit.
• Risk of electric shock, can cause injury or death. DiscOimect all
remain electric power supplies before servicing.
• DO NOT plill out the power cord when the power is ON. This
may cause serious electrical shocks which may result in the
fire hazards.
• Keep the indoor and outdoor Imits, power cable and transmission
wiring, at least 1m from TVs and radios, to prevent distorted
pictures and static. {Depending on the type and source of the
electrical waves, static may be heard even when more than
1m away}.
Lh CAUTION
Please take note of the following important points when
installing.
• Do not install the unit where leakage ofnammable gas may
occur.
' " If
gas leaks and accumulates arOlmd the Imit, it may calise
\.y
fire
ignition.
• Ensure that drainage piping is connected properly.
O
If the drainage piping is not connected properly, it may
cause water leakage which will dampen the fumiture.
• Do uot overcharge the unit.
This Imit is factory pre-charged.
o
Overcharge will calise over-current or damage to the
compressor.
• Eusure that the unit 's panel is closed after service or
installation.
o
Unsecured panels will cause the unit to operate noisily.
• Sharp edges and coil surfaces are potential locations which
may cause injury hazards. Avoid from being in contact with
these places.
• Before turning off the power supply, set the remote
controller's ON/OFF switch to the
''OFF''
position to prevent
the nuisance tripping of the unit. If this is not done, the unit's
fans will start hmling automatically when power resmnes, posing
a hazard to service persomlel or the user.
• Do not install the units at or near doorway.
• Do not operate any heating apparatllS to'o close to the air
conditioner unit or use in room where mineral oil, oil vapour
or oil steam exist, this may callSe plastic part to melt or
deform as a result of excessive heat or chemical reaction.
• When the unit is used in kitchen, keep flour away from going
into suction of the unit.
• This unit is not suitable for factory llSed where cutting oil
mist or iron powder exist or voltage fluct uates greatly.
• Do not install the units at area like hot spring or oil refinery
plant where sulphide gas exists.
• Ensurethecolorofwires of the outdoor unit and the tenninal
markings are same to the indoors respectively.
• IMPORTANT: DO NOT INSTALL OR USE THE AIR
CONDITIONER UNIT IN A LAUNDRY ROOM.
• Don 't lise joined and twisted wires for incoming power
supply.
• The equipment is not intended for use in a potentially
explosive atmosphere.
NOTICE
Disposal requirements
Your air conditioning product is marked \vith this symbol. This means that electrical and electronic products shall not be mixed with
unsorted household waste.
Do not
try
to dismantle the system yourself: the dismantling of the air conditioning system, treatment of the refrigerant, of oil and of
other parts must be done by a qualified installer in accordance with relevant local and national legislation.
Air conditioners must be treated at a specialized treatment facility for re-use, recycling and recovery. By ensuring this product is
disposed of correctly, you will help to prevent potential negative consequences for the environment and human health. Please contact
the installer or local authority for more infonnation.
Batteries must be removed from the remote controller and dispose{) of separately in accordance with relevant local and national
legislation.
1-4
-