Safety Functions; Using The Lithium Packs - Lenz Rcb 1200 Bedienungsanleitung

OPERATING INSTRUCTIONS / ENGLISH
5. Once the lithium packs are fully charged, the charging process automatically ends and
the charge indicator (Fig. 2.2) changes back to green.
6. The charging status can be monitored with the LEDs on the lithium pack, which light up
successively as the charge increases, or using the Lenz heat app* which offers convenient
control.
7. After the end of the charging process, please disconnect both lithium packs from the
charging plugs.
Important note:
Because naturally occurring minimal differences due to production can occur,
￭
the charge indicator in the Lenz heat app* only serves as a general indicator.
If you are using a USB power unit other than the USB power unit included by the
￭
manufacturer, it must meet the mentioned technical specifications and comply
with all applicable safety standards and guidelines.
Charge the product after every use.
￭
This helps extend the life of the lithium packs and ensures that the product is
￭
ready for use at any time.
The battery consists of lithium ion cells and can be charged in any state.
￭
For this reason, the battery does not need to be fully discharged before charging.
￭
The full charging capacity of the product can only be conserved if the product
￭
is disconnected from the charging plugs after the end of the charging process.
Charging time

SAFETY FUNCTIONS

Short circuit protection: In the event of a short circuit at the contact or the heating element,
￭
the integrated electronics automatically turn the product off. After removing the short circuit,
please briefly connect the lithium packs to the charging plugs. Next, press the control button
once and the product is ready again.
Protection against overcharging and exhaustive discharge: The product is protected
￭
against overcharging and exhaustive discharge with the integrated electronics system.
lithium pack rcB 1200
lithium pack rcB 1800
– 24 –
5 – 7 h
7 – 9 h