Operation - Makita TD021D Bedienungsanleitung

For European and North & South American
countries, Australia and New Zealand
A=12mm Use only these type of bit. Follow the
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
006348
For other countries
To install these types of bits, follow
A=17mm
the procedure (1).
B=14mm
(Note) Makita bits are these types.
To install these types of bits, follow
A=12mm
the procedure (2).
B=9mm
(Note) Bit-piece is necessary for
installing the bit.
006349
Fig.6
1. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far
as it will go. Then release the sleeve to secure the
bit.
Fig.7
2. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit-piece and bit into the
sleeve as far as it will go. The bit-piece should be
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.

OPERATION

1
2
1. Straight type
2. Pistol type
010330
The tool can be used in two ways; a straight type and a
pistol type which is selectable according to the
conditions of workplace and screwdriving.
CAUTION:
When bending the tool to use in the pistol type or
•
straightening to use in the straight type, do not hold
the bendable part of the tool. Failure to do so may
cause your hand and fingers to be pinched and
injured by this part.
Hold the tool firmly and place the point of the driver bit in
the screw head. Apply forward pressure to the tool to the
extent that the bit will not slip off the screw and turn the
tool on to start operation.
The proper fastening torque may differ depending upon the
kind or size of the screw/bolt, the material of the workpiece
to be fastened, etc. The relation between fastening torque
and fastening time is shown in the figures.
Standard bolt
N m
(kgf cm)
20
(204)
M8
15
(153)
10
M6
(102)
5
(51)
0 1.0
Fastening time S)
007517
6
(M8)
(M6)
2.0 3.0
(