Functional Description - Makita TD021D Bedienungsanleitung

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.
Always switch off the tool before insertion or
•
removal of the battery cartridge.
Installing or removing battery cartridge
Fig.1
To remove the battery cartridge, withdraw it from
•
the tool while pressing the buttons on both sides of
the cartridge.
To insert the battery cartridge, align the tongue on
•
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If not, it may
accidentally fall out of the tool, causing injury to
you or someone around you.
Do not use force when inserting the battery
•
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Lock lever
Fig.2
When the lock lever is in the locked position
switch cannot be actuated.
When the lock lever is in the unlocked position
switch can be actuated.
Switch action
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch actuates
properly and returns to the "OFF" position when
released.
Fig.3
To start the tool, first move the lock lever to the unlocked
position to release the switch lever.
A
B
1. Switch
010329
And then turn the switch to A side for clockwise rotation
or to B side for counterclockwise rotation.
Tool speed is increased by increasing rotation force on
the switch. Release the switch to stop.
B
A
1
CAUTION:
Always check the direction of rotation before
•
operation.
Change the direction only after the tool comes to a
•
complete stop. Changing the direction of rotation
before the tool stops may damage the tool.
When not operating the tool, always set the lock
•
lever in the locked position
Lighting up the front light
CAUTION:
Do not look in the light or see the source of light
•
directly.
Fig.4
To start the tool, first move the lock lever to the released
position to release the switch.
, the
1. Switch
010329
, the
To put on the light only, rotate the switch to the A or B
side a little.
To not only put on the light but also start the tool rotate
the switch to the A or B side more.
Release the switch to stop the lamp and tool.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the lock lever is in the locked
•
position
removed before carrying out any work on the tool.
Installing or removing driver bit or socket bit
Fig.5
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
5
.
B
A
B
A
1
mark and the battery cartridge is