dB Technologies Moving Bedienungsanleitung Seite 42

ENGLISH
•
Once the procedure is complete, "TX SUCCESSFUL" will appear on the display, then turn off the
transmitter. The device is ready to be used.
8.5 UPDATING FIRMWARE
Just like the configuration, also the firmware is updated via the receiver. Refer to paragraph 4.4
8.6 SHUTDOWN
Press down the "Mode" (6) button for a few seconds, until the shutdown message appears on the display.
8.7 BATTERIES LOW
The battery status is displayed by the specific indicator.
When the level has reached its operating limit, this is indicated by an "exclamation mark"; in this condition the
device will continue operating until the battery is completely discharged.
If the transmitter is turned off with the battery in a critical phase, the device will no longer turn on.
Replacing the batteries:
•
When the transmitter is off, open the front panel on the transmitter.
•
Insert or replace the batteries in the compartment, paying particular attention to the indicated
polarity.
The MOVING D-B transmitter uses two standard AA batteries. It is recommended to use high
capacity (>2200mAh) NiMH batteries.
•
Close transmitter front panel.
WARNING
If the transmitter is not used for a long period,
it is advisable
avoid any
leakage.
41
to remove the batteries to
Moving D – digital wireless microphone system