Updating Firmware - dB Technologies Moving Bedienungsanleitung

ENGLISH
6.4 TRANSMITTER CONFIGURATION
The transmitter is configured through the receiver.
•
Set the desired configurations in the various menus of the MOVING D-R receiver (for more details see the
manual section concerning the receiver).
•
Turn on the transmitter.
•
Unscrew and remove the MOVING D-H transmitter handle. Align the transmitter's IRDA interface with the
one for the receiver (recommended distance between 5 and 10 cm), see figure below.
•
On the receiver: use the Up button to enter menu 1 (TX CONFIGURATION) and turn the Select knob to
select Write Data, then press the button to confirm (OK).
•
Wait for the operation to finish, making sure not to interrupt the IRDA connection between the two devices.
•
Once the procedure is complete, "TX SUCCESSFUL" will appear on the display, then turn off the
transmitter. The device is ready to be used.
6.5

UPDATING FIRMWARE

Just like the configuration, also the firmware is updated via the receiver. Refer to paragraph 4.4.
6.6 SHUTDOWN
Press down the "Mode" (1) button for a few seconds, until the shutdown message appears on the display.
6.7 BATTERIES LOW
The battery status is displayed by the specific indicator. When the level has reached its operating limit, this is
indicated by an "exclamation mark"; in this condition the device will continue operating until the battery is
completely discharged.
If the transmitter is turned off with the battery in a critical phase, the device will no longer turn on.
Replacing the batteries:
•
Unscrew the transmitter handle and remove it from the microphone body.
•
Insert or replace the batteries in the compartment, paying particular attention to the indicated polarity.
The MOVING D-H transmitter uses two standard AA batteries. It is recommended to use high
capacity (>2200mAh) NiMH batteries.
•
Put the transmitter handle back on.
WARNING
If the transmitter is not used for a long period, it is advisable to remove the batteries to avoid any
leakage.
37
Moving D – digital wireless microphone system