Main Screen - dB Technologies Moving Bedienungsanleitung

ENGLISH
7) "I.R."
Device for IrDA (infrared) communication with the MOVING D-R receiver.
8) Antenna
Attention!!! Do not bend or straighten the antenna.
9) Front panel
Panel that closes the battery compartment and the internal adjustment buttons.
10) Front panel open buttons
Pressing them at the same time releases the front panel, so it can be opened.
11) Battery compartment
Compartment for inserting the batteries supplied.
The MOVING D-B transmitter uses two standard AA batteries. It is recommended to use high
capacity (>2200mAh) NiMH batteries for longer life.
7.2.1 CUSTOMISING THE TRANSMITTER
Five colored interchangeable silicon rings are supplied to customize the transmitter if multiple systems are used
at the same time.
These rings are inserted in the body of the XLR connector for the accessory (microphone or guitar cable).
The transmitter can also be customized by setting the user's name from the receiver (for more information refer to
paragraph 3.6.2).
8 TRANSMITTER OPERATION MOVING D-B
Open the front panel (10) of MOVING D-B transmitter, insert the batteries in the compartment (11) making sure
the batteries are in the correct direction.
8.1 START-UP
Turn on the transmitter by pressing the "MODE" (6) key for a few seconds until the display (1) turns on.
There will be a brief initialization procedure, during which "dB Technologies Initializing..." will appear on the
display, and after a few seconds transmitter will be ready. and the blue status LED flashes once every 4
seconds.
8.2 ENERGY SAVINGS
After about 10 seconds, the display will enter the energy savings mode. This status is indicated by an asterisk.
To exit this mode, press and immediately release the "MODE" (6) key.
8.3 FUNCTIONS ON THE DISPLAY
The basic configurations of the MOVING D-B transmitter will be shown on the display.
8.3.1

MAIN SCREEN

This is the default screen that appears after the device is turned on.
This screen displays:
•
The name of the microphone user, if set from the receiver. If not set, the default message will appear :
"SingerName".
•
The frequency value (expressed in MHz) of the transmission channel currently being used.
•
The "active microphone" (loudspeaker) or Mute (crossed off loudspeaker) status indicator.
•
The mute indicator.
•
The battery level indicator.
39
Moving D – digital wireless microphone system