Energy Savings - dB Technologies Moving Bedienungsanleitung

6 MOVING D-H TRANSMITTER OPERATION
Unscrew the handle (4), of your MOVING D-H transmitter, insert the batteries in the compartment (6) making sure
the batteries are in the correct direction.
6.1 START-UP
Turn on the transmitter by pressing the "MODE" (1) key for a few seconds until the display (2) turns on.
There will be a brief initialization procedure, during which "dB Technologies Initializing..." will appear on the
display, and after a few seconds transmitter will be ready.
6.2

ENERGY SAVINGS

After about 10 seconds, the display will enter the energy savings mode. This status is indicated by an asterisk.
To exit this mode, press and immediately release the "MODE" (1) key.
6.3 FUNCTIONS ON THE DISPLAY
The basic configurations of the MOVING D-H transmitter will be shown on the display.
6.3.1 MAIN SCREEN
This is the default screen that appears after the device is turned on.
This screen displays:
•
The name of the microphone user, if set from the receiver. If not set, the default message will appear :
"SingerName".
•
The frequency value (expressed in MHz) of the transmission channel currently being used.
•
The "active microphone" (loudspeaker) or Mute (crossed off loudspeaker) status indicator.
•
The mute indicator.
•
The battery level indicator.
MUTE
The Mute status is indicated on the transmitter by the crossed off loudspeaker symbol.
To switch from the normal status (functioning) to Mute, or vice versa, hold down the button (1) for a second.
6.3.2 SCREEN 2
Press and release rapidly the button (1) to switch from the main screen to screen 2.
This screen displays:
•
The version of the firmware installed in the device.
•
The microphone capsule amplification gain (expressed in dB).
•
The power of the signal transmitted to the receiver (expressed in mW).
•
The mute indicator.
•
The battery level indicator.
ENGLISH
36