dB Technologies Moving Bedienungsanleitung Seite 32

ENGLISH
3.6.5 MENU 5 - FW VERSION
This menu can be used to check the versions of the firmware installed in the device.
3.6.6 MENU 6 - MANUAL FREQUENCY
This menu can be used to manually select the frequency.
•
Use the knob (4) to select "Select", then press it to access the change mode. Turn the knob to position the
arrow on the number to be modified, then press to confirm.
•
Select "Frequency" and change as necessary the number indicated by the previously set arrow, press the
knob to confirm the desired frequency.
•
Enable the use of the set frequency by changing the status of the "Activate" parameter from OFF to ON.
•
Follow the data writing procedure in paragraph 3.6.1 to configure the transmitter.
Note. For the best results, it is recommended to use frequencies with little background noise.
It is recommended to set the Buffer parameter in menu "8 SCAN SETUP" to zero.
Attention!!!
When manually setting the value of the frequency, all the frequencies between 470 and 870 MHz can
be accessed, including the values that may be prohibited in the country where the system is used.
To avoid any penalties, it is recommended to consult the regulations of the country of use.
3.6.7 MENU 7 - SCAN
Menus 7 and 8 concerning frequency scanning. The time required for scanning the frequencies varies depending
on the set frequency interval.
•
Use the knob (4) to select the arrow located above the frequency values. Press it to access the change
mode. Turn the knob to position the arrow on the number to be modified, then press it again to confirm.
•
Select the "Min" or/and "Max" frequency value and change as necessary the number indicated by the
previously set arrow.
frequencies to be analyzed.
•
"Start" parameter: select between "Full" and "Quick" scanning:
"Quick" scanning
Selecting Quick activates the scanning of the frequency range, related to the selected country, for the channels in
the banks.
"Full" scanning
Selecting Full activates the scanning of all frequencies within the selected range. For this type of scan, the
parameters in this menu as well as those in menu 8 "SCAN SETUP" must be set.
The Full mode may be more accurate than the Quick mode, but may also require a few minutes before it is
completed.
31
Press the knob to confirm the extreme values of the desired interval of the
Moving D – digital wireless microphone system