Write Data - dB Technologies Moving Bedienungsanleitung

ENGLISH
3.6.1 MENU 1 - TX CONFIGURATION
From this menu it is possible, via the IRDA device, to write (Write Data) or read (Read Data) the parameters set
of the two devices.

WRITE DATA

•
Set the desired configurations in the various receiver menus (for more details see below in the manual).
•
Turn on the transmitter.
•
Align the transmitter's IRDA interface with the one for the receiver (recommended distance between 5 and
10 cm). For more information refer to paragraph 5 MOVING D-H and paragraph 7 for MOVING D-B.
•
Use the Up (5) button to enter receiver menu 1 and turn the Select (4) knob to select Write Data, then
press the knob to confirm (OK).
•
Wait for the operation to finish, making sure not to interrupt the IRDA connection between the two devices.
•
Once the procedure is complete, "TX SUCCESSFUL" will appear on the display, then close the
transmitter. The devices are synchronized and are ready for use.
READ DATA
•
Turn on the transmitter.
•
Align the transmitter's IRDA interface with the one for the receiver (recommended distance between 5 and
10 cm). For more information refer to paragraph 5 for MOVING D-H and paragraph 7 for MOVING D-B.
•
Use the Up (5) button to enter receiver menu 1, turn the Select (4) knob to select Read Data, then press
the knob to confirm (OK).
•
Wait for the operation to finish, making sure not to interrupt the IRDA connection between the two devices.
•
Once the procedure is complete, "RX SUCCESSFUL" will appear on the display, then turn off the
transmitter. The devices are synchronized and are ready for use.
DEFAULT DATA
If necessary, the default configuration can be restored using the Default Data function on page 1 of the menu:
TX Configuration.
3.6.2 MENU 2 - PARAMETERS A
From this menu, it is possible to set the gain of the hand-held transmitter's microphone capsule and the name to
be assigned to the hand-held or bodypack transmitter.
SETTING THE GAIN FOR THE CAPSULE (TX Audio Level)
•
Select "TX Audio Lev" and turning the knob (4), select the desired value, press the knob to confirm.
•
Follow the data writing procedure at paragraph 3.6.1 to configure the transmitter.
SETTING THE TRANSMITTER NAME (Name)
•
Use the Select (4) knob to individually select and modify each letter or character to obtain the desired
name (max 11 characters). Press the knob to confirm each character.
•
Follow the data writing procedure in paragraph 3.6.1 to configure the transmitter.
SET THE RECEIVER ID NUMBER (MOVING D ID) ( Only for use with HUB 800)
•
By turning knob (4), select and push to enable the modification, select the desired ID number in a range of
1 to 6, then press the knob to confirm.
This setting allows to identify the receiver inside the rack and to communicate with an outside PC.
After Operation of Default Data (Par 3.6.1) the ID of the Receiver will be reset to Default value
"1". On multi-microphone System with HUB the user MUST manually set the ID; each receiver
MUST have a different ID, to avoid an issue on the function of the System.
29
Moving D – digital wireless microphone system